Sony rmv310 manual

Quick Links. The left row of the table shows the brand and the right row shows the. The left row of the table shows the brand, and the right two rows show. The left row of the table shows the brand, and the right four rows show.

La colonne gauche du tableau indique la marque et la colonne droite le. La colonne de gauche du tableau indique la marque et les deux. La colonne gauche du tableau indique la marque et les quatre colonnes. La fila izquierda de la tabla muestra la marca y la derecha muestra el. La fila izquierda de la tabla muestra la marca, y las dos filas de la. Sistema de minicomponentes de alta fidelidad. La fila de la izquierda de la tabla muestra la marca y las cuatro filas de.

To set a Component Code see the instruction manual for details. Pour enregistrer un code d'appareil voir le mode d'emploi pour les. For U. While holding that button, enter the channel number you would like to have the remote transmit on the numerical keypad. Up to four digits can be saved, including a final [Ent] command.

To save the macro, release the button you are holding. Select the component button that contains the macro you would like to reset. Hold down the macro button you wish to clear, enter [0] and [Ent] in sequence, then release the macro button. Now choose the Component Select button you would like to configure. Enter the four-digit code as found on the code list, followed by [Enter] to save.

If the [Set] LED flashes five times the code number entered was invalid, try again. Note: it is not necessary to reconfigure a component button to control a particular type of device, as this is done automatically when a code is entered.

All component buttons except for [TV] can be changed from their default device type. When your device turns on or off, press [Enter] to save. Note: when all available codes for a device category have been searched through, the component LED will flash once. If the remote has been programmed in the past and code search does not appear to be working , enter the default Sony preset code to ensure that the button is set to control the correct type of device.

Press the [Power], [Input] and [Volume -] buttons simultaneously. The following page was printed from RemoteCentral. A Second Conclusion. User Reviews. Message Forum. Search for preset codes: Press [Set] and [Power] at the same time. Change the type of component on a button: Press [Set] and [Power] at the same time.

Program channel macros: Select the component button you would like to program the macro for.